Meters
Home     Frequency Meter   Resistance Meter   Potentiometer   Voltmeter Meter   8051 frequency counter   rf frequency counter   portable frequency counter   word frequency counter   agilent frequency counter   pic frequency counter   ground resistance meter   All Tags
Home ›› Voltmeter Meter ›› Simple Variable Voltage Regulator Using LM317T
   
 You may find:
Amprobe ; napa voltage regulator tester ; tester Voltage Detector ; tester high voltage
 Popular Tags:
voltage meter greenlee | voltage meter measure | 3-6 cells rc lipo battery portable voltage meter | ac line voltage meter | pc atx btx itx lcd power supply voltage meter tester | High Voltage Capacitors | Vdr | Crank High Voltage | Virtual Data Room | High Voltage Test Equipment
Simple Variable Voltage Regulator Using LM317T

Tag:voltage tester circuits voltage tester | 26 Viewers| simple-circuit 2009-06-24 11:44:00 Publish:

This is a simple circuit that can use as voltage regulator. This circuit is adjusts by LM317T as core of the circuit. LM317T is adjustable 3 terminal positive voltage regulators capable of supplying in excess of 1.5 amps over an output range of 1.25 to 37 volts. The figure of the variable voltage regulator using LM317T is in below;


The principle work of this circuit is output voltage is set by two resistors R1 and R2 connected as shown below. The voltage across R1 is a constant 1.25 volts and the adjustment terminal current is less than 100uA. The output voltage can be closely approximated from Vout=1.25 * (1+(R2/R1)) which ignores the adjustment terminal current but will be close if the current through R1 and R2 is many times greater. A minimum load of about 10mA is required, so the value for R1 can be selected to drop 1.25 volts at 10mA or 120 ohms. Something less than 120 ohms can be used to insure the minimum current is greater than 10mA. The example below shows a LM317 used as 13.6 volt regulator. The 988 ohm resistor for R2 can be obtained with a standard 910 and 75 ohm in series.

When power is shut off to the regulator the output voltage should fall faster than the input. In case it doesn't, a diode can be connected across the input/output terminals to protect the regulator from possible reverse voltages. The power transformer should be large enough so that the regulator input voltage remains 3 volts above the output at full load, or 16.6 volts for a 13.6 volt output.

Yahoo: voltage tester Simple Variable Voltage Regulator Using LM317T voltage tester circuits
Google: voltage tester circuits Simple Variable Voltage Regulator Using LM317T voltage tester
Post your comment about:    Simple Variable Voltage Regulator Using LM317T

   

Topics: Frequency Meter Resistance Meter Potentiometer Voltmeter Meter
All Contents was collected by orders.If you have any problem please Click Me © 2008 Meters Time 0.081315 S(s).Query 5.